B&G Nemesis Power/Ethernet Hub Interconnect Cable — Electrical Accessories
The B&G Nemesis Interconnect Cable (000-15740-001) is a 0.6 m (2 ft) combined power and Ethernet cable that links individual Nemesis sailing displays to the Nemesis Hub over a single 8-pin connector.
One unit is required per display to be connected to the Hub.
Marine electronics technicians and sailboat riggers install the cable during hub-based multi-display setups at the mast or helm station.
Compatibility & Applications
- Pairs with the B&G Nemesis Hub, which supports connection of up to 3 Nemesis displays at a key location such as the mast or helm.
- Fits B&G Nemesis 9-inch and Nemesis 12-inch sailing instrument displays via the hub’s 8-pin Ethernet display port.
-
Pairs with main Power/Ethernet cable runs available in lengths from 5 m to 30 m
, reducing total cable count to a single backbone run plus one interconnect per display. - Wires to a vessel’s B&G CPU Ethernet network for data transfer to displays, and integrates with the vessel’s NMEA 2000 network.
- Mounts at helm stations and mast locations on sailboats, racing monohulls, and performance cruising yachts from 30 ft and up where multiple Nemesis displays are co-located.
- Requires no special setup for establishing an Ethernet network once connected at the hub.
In a twin-display mast installation on a 40 ft cruiser-racer, two interconnect cables route from the Nemesis Hub to a Nemesis 9 and a Nemesis 12 mounted side by side, while a single 10 m Power/Ethernet cable serves as the only long cable run — eliminating the need for individual power drops to each display.
The hub end of the cable terminates to one of three 8-pin Ethernet connections on the Nemesis Hub.
